On Windows 10/11, you may need to disable "Driver Signature Enforcement" in the advanced boot menu to install older Cutok drivers.
Follow the prompts until you see a "Driver Install Success" message. 3. Connect the Hardware Plug the USB cable into the cutter and then into the PC. Turn the power switch on. Windows should chime, recognizing the new hardware. ⚙️ Configuring the COM Port
Usually requires a specialized "Cutout" plugin rather than a standard printer driver. cutok dc330 driver installer
Look for downloads under "Huiyi" or "Cutok" official support pages.
If you still have the mini-disk that came with the box, the driver is located in the Driver or USB Driver folder. On Windows 10/11, you may need to disable
If the cutter starts moving erratically, the Baud Rate is likely wrong. Standard setting for the DC330 is usually 9600 . 🔌 Software Compatibility
The most common reason a Cutok DC330 won't cut is a COM port mismatch. Open on your PC. Expand the Ports (COM & LPT) section. Look for "USB-SERIAL CH340" or similar. Note the number (e.g., COM3 ). Connect the Hardware Plug the USB cable into
In your cutting software (Artcut, SignMaster), go to and ensure the output port matches that specific COM number. ⚠️ Troubleshooting Common Issues