!!better!! — Gateman V20 Manual

Note: Registering a new card will typically delete all previously registered cards, so scan them all in one session.

When you are inside, slide the "Double Lock" switch to the red position. This prevents the door from being opened from the outside, even with a valid PIN or card.

Touch each one by one to the card reader on the exterior unit. (You will hear a beep for each successful scan). Press the [I] button to finish. gateman v20 manual

To prevent strangers from guessing your code via fingerprint smudges, the V20 requires you to touch the keypad with your palm before or after entering your PIN.

Enter your desired on the exterior keypad. Press the [*] button or the [I] button again to complete. 2. Registering Key Tags (RF Cards) The V20 supports key tags for quick, "tap-and-go" entry. Open the battery cover and press the [I] button. Note: Registering a new card will typically delete

This guide provides a comprehensive overview of the , a popular rim-type digital door lock known for its slim design and reliability. Whether you’ve just installed one or need to troubleshoot, here is everything you need to know about operating and maintaining your device. 1. Getting Started: Initial Setup

Check if the batteries are inserted correctly or try a 9V emergency battery. Touch each one by one to the card

There is a toggle switch inside the battery compartment. Auto: The door locks automatically seconds after closing.

You must touch the keypad or press the button to lock it.

When the batteries are low, the lock will play a specific melody (often "To Elise") after every use. Change them immediately.