Gemel Txshs User Manual Extra Quality May 2026

Ensure the remote is within the motorcycle's reception range. Turn the ignition key to the ON position.

Insert the new battery, ensuring it does not touch other electrical components. The LED should light up once the battery is in place.

Turn the ignition OFF . Test the remote by arming and disarming the bike. Maintenance: Battery Replacement The Gemel TXSHS uses a CR 2032 3V lithium battery. Gemel Txshs User Manual

The turn indicators will flash three times, and the alarm tone will sound three times to confirm the motion sensor is off.

The system enters a 15-second "activation phase" where no alarm will be triggered. After this, it is fully active. Ensure the remote is within the motorcycle's reception range

Release both buttons. The LED should now stay on. Press either Button 1 or Button 2 once. The LED should turn off.

If the sync procedure fails, check the battery voltage. Low battery is the most common cause of pairing issues. Gemel TXSHS alarm operating advice needed - UKGSer The LED should light up once the battery is in place

Provides visual feedback during operation and synchronization. Basic Operation Arming the Alarm

Hi all, As I mentioned in one of my previous posts I was going to change the two small batteries in my BMW alarm box (Gemel TXSHS) Gemel TXSHS alarm operating advice needed - UKGSer