Plug your 4-pin NEMA 17 stepper motors into the corresponding ports. If a motor spins in the wrong direction, you can flip the plug or change the direction in the GRBL settings ($3). 4. Laser or Spindle
Use the Spindle relay or PWM output to control your motor tool. 💻 Software Configuration makerbase mks dlc v21 manual link
Ensure you have the CH340 driver installed on your computer. Plug your 4-pin NEMA 17 stepper motors into
Since the MKS DLC v2.1 runs GRBL, it is compatible with a wide range of open-source software. Recommended Software The best free option for laser engraving. makerbase mks dlc v21 manual link