12V DC power from the Challenger LAN or an external power supply.
Use the base as a template to mark screw holes. Use appropriate fasteners for the mounting surface (e.g., wall plugs for masonry). 2. Wiring and Terminals
For environments where the keypad face may become worn, a replacement TS1162-LABEL (membrane) is available to restore the unit's appearance and button legibility. ts1162 installation manual
Pull the bottom of the body away from the base and lift it off the top tabs.
If the TS1162 is the last device on a long RS-485 cable run, set the termination DIP switch (typically Switch 8) to the 'ON' position to prevent data signal reflections. 4. System Integration 12V DC power from the Challenger LAN or
All power should be disconnected from the Challenger panel before wiring the RAS. The TS1162 typically features a pre-wired tail or screw terminals for the following connections: Connection Description
For further technical support or to download the full PDF documentation, visit the Aritech Support Portal or Ness Corporation . If the TS1162 is the last device on
RS-485 data lines for communication with the Challenger panel. Request to Exit (RTE) input for controlling door egress. OUT (Open Collector) A 50mA output used to drive a door relay or door strike.
Ensure the mounting surface allows the rear tamper lever to be fully depressed when the unit is secured. Enclosure Removal: Undo the retaining screws at the bottom of the keypad.
The is a 3-LED Remote Arming Station (RAS) designed for use with Challenger security systems. Rated at IP67 , this robust keypad is suitable for both indoor and outdoor installations, including harsh, dusty, or wet environments.