Right-click the setup file and select Run as Administrator . Follow the on-screen prompts to complete the installation.
Tick the Program box, click browse, and select the rawprogram file from your firmware folder. This will automatically load the associated patch files.
Open the QC Fire module from the desktop shortcut or the UMT Support Access interface. How to Flash Firmware with QcFire Select Tab: Navigate to the Flasher tab.
Temporarily disable real-time antivirus protection to prevent the deletion of tool components during installation. 2. Installation Steps
Power off the device. Connect it to the PC while holding the Volume Up and Down buttons (or using a test point) to enter EDL Mode (Qualcomm HS-USB QDLoader 9008) .
Once the tool detects the device, click Flash . Wait for the "Operation Finished" message before disconnecting.
Install Qualcomm USB Drivers to ensure the PC recognizes the device in EDL mode.
To use the tool, you must have the or a supported box like the NCK Pro . 1. Prerequisites Hardware: Connect your UMT Dongle to a USB port.
Full read/write flashing using XML or program files, often performed in EDL (Emergency Download) Mode .
Launch the UMT Card Manager to update the card firmware and counter before first-time use.
Right-click the setup file and select Run as Administrator . Follow the on-screen prompts to complete the installation.
Tick the Program box, click browse, and select the rawprogram file from your firmware folder. This will automatically load the associated patch files.
Open the QC Fire module from the desktop shortcut or the UMT Support Access interface. How to Flash Firmware with QcFire Select Tab: Navigate to the Flasher tab.
Temporarily disable real-time antivirus protection to prevent the deletion of tool components during installation. 2. Installation Steps
Power off the device. Connect it to the PC while holding the Volume Up and Down buttons (or using a test point) to enter EDL Mode (Qualcomm HS-USB QDLoader 9008) .
Once the tool detects the device, click Flash . Wait for the "Operation Finished" message before disconnecting.
Install Qualcomm USB Drivers to ensure the PC recognizes the device in EDL mode.
To use the tool, you must have the or a supported box like the NCK Pro . 1. Prerequisites Hardware: Connect your UMT Dongle to a USB port.
Full read/write flashing using XML or program files, often performed in EDL (Emergency Download) Mode .
Launch the UMT Card Manager to update the card firmware and counter before first-time use.
