Turn the device back on normally without holding any other buttons.
Reconnect to the PC. If it boots correctly, the "VID_1F3A" entry will disappear and be replaced by the standard device name (e.g., "Android Device" or "MTP Device").
If you intend to flash the device (e.g., using PhoenixSuit ), you need the driver so Windows 11 can communicate with the chip. usb device-vid-1f3a-pid-efe8- windows 11
Specifically indicates the device is in FEL mode , a special state for flashing firmware via tools like LiveSuit or PhoenixSuit.
Press and hold the for at least 15–20 seconds to force a full shutdown. Turn the device back on normally without holding
For advanced developers, you can use the Zadig tool to force-install a generic WinUSB driver to this hardware ID to allow communication with tools like sunxi-fel . 3. Address "Device Not Recognized" Errors
If Windows 11 displays a "USB Device Not Recognized" notification: Topic: Error USBdevice(vid-1f3a-PID-efe8) @ AskWoody If you intend to flash the device (e
The hardware ID USB\VID_1F3A&PID_EFE8 identifies a device in . This is a low-level "recovery" or "programming" state common in tablets and single-board computers (like Orange Pi or older Android tablets) using Allwinner processors.
Locate the device with the yellow exclamation mark (labeled "Unknown" or VID_1f3a_PID_efe8 ).
Look for the "Allwinner USB Driver" or "FEL Mode Driver" from trusted sources like DriverPack or Treexy . Manual Installation: Open Device Manager (Right-click Start > Device Manager).