Avoid running continuous loads right at the 10A limit to prevent the relay from overheating.
The module calculates the battery percentage using the formula:
Long press the DOWN button to toggle the backlight sleep mode. "On" keeps the light on; "OFF" turns the light off after 5–10 minutes of inactivity. Safety Precautions xycd60 manual
The is a versatile digital battery charging and discharging controller module designed to manage battery health by preventing overcharging and over-discharging . It is commonly used in DIY electronics, solar power setups, and battery maintenance systems. Core Functionality
In this mode, the module connects the charger to the battery when the voltage drops below a set lower limit () and disconnects it when the battery reaches the upper limit ( UP ). Condition to Start: Voltage ≤is less than or equal to dn . Condition to Stop: Voltage ≥is greater than or equal to UP . 2. Discharging Mode (dn) Avoid running continuous loads right at the 10A
This mode is used to protect batteries from deep discharge. The module connects the load when the battery is full and disconnects it once the voltage hits a minimum threshold. Voltage ≥is greater than or equal to UP . Condition to Stop: Voltage ≤is less than or equal to dn . Setting Up the XY-CD60 Entering Setup
High-definition LCD screen showing voltage, percentage, and time. Modes: Charging Mode ( UP ) and Discharging Mode ( dn ). Operating Modes Explained 1. Charging Mode (UP) Safety Precautions The is a versatile digital battery
for about 3 seconds to enter the parameter setting interface. Short press SET to cycle through the parameters: UP : Upper limit voltage. dn : Lower limit voltage. OP : Conduction time (00:00 to 99:59, or "----" to disable). dOP : Delayed conduction time (0–999 seconds). FOP : Forced start time (0–10 seconds) in discharge mode. Use UP/DOWN buttons to adjust the values. Press and hold SET again to save and exit. Voltage Percentage Calculation
If OP is set, the relay will automatically disconnect after the specified duration, even if the voltage threshold hasn't been reached. This acts as a safety backup.