Zk5kx Manual May 2026

To change a value, press the knob to select the digit and rotate to adjust. Long-press again to save and exit. 5. Calibration (Use with Caution)

Short press to toggle the output on or off. Long press (2 seconds) to switch the display between the input voltage and output voltage.

Short press to enter the Voltage and Current setting interface. 3. How to Set Voltage and Current zk5kx manual

If your multimeter shows a different reading than the ZK-5KX screen, you can calibrate it: Long-press to enter the settings. Scroll to find SET (calibration mode).

Avoid connecting the "Input -" and "Output -" wires together. This will bypass the current sensing resistor and could cause the module to fail or lose current limiting capabilities. To change a value, press the knob to

Used to adjust values. It also acts as a button when pressed.

Setting your limits is the most important part of using the ZK-5KX. Calibration (Use with Caution) Short press to toggle

Short press to cycle through the bottom display options (Current (A), Power (W), Capacity (Ah), and Time (h)).

To access the deeper "Software Protection" menu, for 2 seconds while the output is off. Turn the knob to scroll through these parameters:

The is a versatile DC-DC adjustable step-up/step-down power supply module. Whether you are building a DIY lab bench power supply, charging batteries, or driving LEDs, this module packs a lot of punch into a small form factor. 1. Key Specifications Input Voltage: 6.0V – 36V Output Voltage: 0.6V – 36V Output Current: 0 – 5.0A